Electric Fire Transducer Glass Disk Heater Dimplex M-011B M011B Opti-Myst Electric Wall Fire Replacement Heater Stove Parts Spares Discs

Fits models:

For DIMPLEX, RTOPCS20, RTOPW20, RTOPI20BR, RTOPI20CH, BBK20 (Series A – D) ‘ BBK20 (Series E) ‘ BRG20 (Series A ) ‘ DNV20CH (Series A – Onward ) ‘ DNV20AB (Series A – C) ‘ DNV20BL (Series A – Onwards) ‘ DNV20BR (Series A – C) ‘ MFD20 (Series A) ‘ OKT20 (Series A) ‘ RDY20 (Series A – D) ‘ RDY20 (Series E) ‘ SCR20 (Series A) ‘ SCR20 (Series K) ‘ TAH20 (Series A) ‘ TAH20 (Series E) ‘ WBK20 (Series A) ‘ WMR20 (Series A) ‘ ALM20 (Series A) ‘ AUB20 (Series A) ‘ CAS600 ‘ CAS400NHLL ‘ CAS400HLL ‘ CAS600NH ‘ RTOPCS20 ‘ RTOPW20 ‘ RTOPI20BR ‘ RTOPI20CH ‘ SVT20 (Series A)

Ceramic disc diameter:20mm (not include rubber)

Power: 17W

Working voltage: DC24V

Working current: 700MA

Humidification capacity: 350ML/H

Ultransmit M-011B MFD 201312 DC24V 500mA or M011B-1C A3 4414 #CHM4312.

Package Contents:

1 xTransducer

4 xTransducer Disks

1 x Key(used to open the lid while replacing the discs)

Note:

1. The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness.

2. Please allow slight manual measurement deviation for the data.

Purify fresh air: Remove the smell of mildew, smoke, smell and paint, so as to keep the indoor air fresh and fresh.Easy to operate.24V safe voltage. Plug in the power and put it into the water to work.
Multifunctional Ultrasonic fogger: Aerosolized amount ≥ 400 mL / H. It can make enough fog to purify the unpleasant smell in the water.Spare discs and removal tool for your Dimplex electric wall fire. Optimum position for transducer in the water is 5cm.
Wide range of uses: The electric fire transducer can be used to create fog in fireplaces to form flame effects, it can be used for atomization and disinfection of disinfection equipment, and it can also be used for fish tank landscaping
Intelligent control: a built-in low water level sensor, if the water level becomes too low, the device can be automatically closed. The atomizer slightly heats up when it is working, but it will not become too hot when the water is placed.
Please note: replacement of your transducer may be required if no mist is being produced, or if the fire cuts off after 30 seconds. There are several other components which may also contribute to lack of mist, or premature cutting out – such as a faulty sump fan unit, a build-up of calcium deposits, insufficient / incorrect water level in the tank, faulty lamps, damage to the mist nozzle or incorrect fitting of the transducer.